Printed placeholder cards and scissors next to an open binder

Disney Lorcana

Omnidroid binder placeholders

One placeholder for each of the 10 cards in the Omnidroid master set, in binder order. Each is standard card size (63 × 88 mm), so it drops into a pocket and tells you which card belongs there.

Open the checklist

  1. Print at 100% scale, not “fit to page”, on Letter or A4. Card stock holds up better than paper.
  2. Cut along the dashed lines. There are nine placeholders on each sheet.
  3. Slot them in order. The small page on each one shows which pocket it goes in.
Set 12binderlore.comOmnidroid – V.8NormalPage 1, pocket 1173/204Common#1
Set 12binderlore.comOmnidroid – V.8Cold FoilPage 1, pocket 2173/204Common#2
Set 12binderlore.comOmnidroid – V.9NormalPage 1, pocket 3184/204Uncommon#3
Set 12binderlore.comOmnidroid – V.9Foil, Cold FoilPage 1, pocket 4184/204Uncommon#4
Set 12binderlore.comOmnidroid – V.10NormalPage 1, pocket 5190/204Rare#5
Set 12binderlore.comOmnidroid – V.10Cold FoilPage 1, pocket 6190/204Rare#6
Set 13binderlore.comOmnidroid – Scanning for ThreatsNormalPage 1, pocket 7188/207Common#7
Set 13binderlore.comOmnidroid – Scanning for ThreatsCold FoilPage 1, pocket 8188/207Common#8
Set 13binderlore.comOmnidroid – Ultimate IterationNormalPage 1, pocket 9196/207Rare#9
Set 13binderlore.comOmnidroid – Ultimate IterationCold FoilPage 2, pocket 1196/207Rare#10

See it on TCGplayer (opens in a new tab)