Printed placeholder cards and scissors next to an open binder

One Piece Card Game

Hatchan binder placeholders

One placeholder for each of the 13 cards in the Hatchan master set, in binder order. Each is standard card size (63 × 88 mm), so it drops into a pocket and tells you which card belongs there.

Open the checklist

  1. Print at 100% scale, not “fit to page”, on Letter or A4. Card stock holds up better than paper.
  2. Cut along the dashed lines. There are nine placeholders on each sheet.
  3. Slot them in order. The small page on each one shows which pocket it goes in.
OP-PRbinderlore.comHatchanCS 2024 Celebration PackPage 1, pocket 1OP03-033Uncommon#1
OP-PRbinderlore.comHatchanTournament Pack Vol. 6Page 1, pocket 2OP03-033Uncommon#2
OP-PRbinderlore.comHatchanWinner Pack Vol. 6Page 1, pocket 3OP03-033Uncommon#3
OP03binderlore.comHatchanPage 1, pocket 4OP03-033Uncommon#4
OP03binderlore.comHatchanPage 1, pocket 5OP03-033Uncommon#5
OP06binderlore.comHatchanPage 1, pocket 6OP06-031Uncommon#6
OP06binderlore.comHatchanPage 1, pocket 7OP06-031Uncommon#7
OP11binderlore.comHatchanPage 1, pocket 8OP11-034Common#8
OP11binderlore.comHatchanPage 1, pocket 9OP11-034Common#9
OP12binderlore.comHatchanPage 2, pocket 1OP12-013Common#10
OP12binderlore.comHatchanPage 2, pocket 2OP12-013Common#11
OP14binderlore.comHatchanPage 2, pocket 3OP14-051Common#12
OP14binderlore.comHatchanPage 2, pocket 4OP14-051Common#13

See it on TCGplayer (opens in a new tab)