Printed placeholder cards and scissors next to an open binder

One Piece Card Game

Makino binder placeholders

One placeholder for each of the 14 cards in the Makino master set, in binder order. Each is standard card size (63 × 88 mm), so it drops into a pocket and tells you which card belongs there.

Open the checklist

  1. Print at 100% scale, not “fit to page”, on Letter or A4. Card stock holds up better than paper.
  2. Cut along the dashed lines. There are nine placeholders on each sheet.
  3. Slot them in order. The small page on each one shows which pocket it goes in.
OP-PRbinderlore.comMakinoJapanese 1st Anniversary SetPage 1, pocket 1OP02-015Uncommon#1
OP-PRbinderlore.comMakinoJudge Pack Vol. 4Page 1, pocket 2ST13-012Common#2
OP-PRbinderlore.comMakinoPremium Card Collection -Best Selection Vol. 3-Page 1, pocket 3ST13-012Common#3
OP02binderlore.comMakinoPage 1, pocket 4OP02-015Uncommon#4
OP02binderlore.comMakinoPage 1, pocket 5OP02-015Uncommon#5
ST-08binderlore.comMakinoPage 1, pocket 6ST08-009Common#6
ST-13binderlore.comMakinoPage 1, pocket 7ST13-012Common#7
ST-13binderlore.comMakinoParallelPage 1, pocket 8ST13-012Common#8
PRB-01binderlore.comMakinoFull ArtPage 1, pocket 9OP02-015Uncommon#9
PRB-01binderlore.comMakinoJolly Roger FoilPage 2, pocket 1OP02-015Uncommon#10
OP-DDbinderlore.comMakinoPage 2, pocket 2OP02-015Uncommon#11
OP13binderlore.comMakinoPage 2, pocket 3OP13-015Uncommon#12
OP13binderlore.comMakinoPage 2, pocket 4OP13-015Uncommon#13
EB03binderlore.comMakinoPage 2, pocket 5EB03-009Common#14

See it on TCGplayer (opens in a new tab)